Intellinet 525497 Instrukcja Użytkownika Strona 13

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 82
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 12
13
Step 3: Install the upper housing and make sure the housing is well installed.
Step 4: Complete the hardware installation as shown below.
Install PoE Injector
DC: Insert adapter
PoE: This jack is linked to the secondary port of the AP with RJ45.
LAN: This jack is linked to the LAN side of a PC/hub or router/ADSL modem device with RJ45.
There is no software driver or utility installation needed only the configuration settings. Refer to
Chapter 4 for software configuration.
Notice: It will take about 50 seconds to complete the boot-up sequence after powering on. The Power
LED will light, then the WLAN Activity LED will flash to indicate the WLAN interface is enabled and
operational.
Przeglądanie stron 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 81 82

Komentarze do niniejszej Instrukcji

Brak uwag